Operating Instructions and Parts Manual Horizontal Band Saw Models HBS-916W; HBS-1018W WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road L
107. Material to be cut must be securely held in vise. 8. Check to see that coolant level is adequate and turn on coolant pump if material to be cu
11Adjusting Feed Rate Rate of feed is adjusted by turning the cutting pressure control knob on the control panel. Rate of feed is important to band s
12 9. Tension blade to approximately 25,000 lbs. of blade tension, as indicated on the blade tension indicator found on the tension wheel shaft hous
13Automatic Shut‐Off Adjustment The motor should shut off immediately after the blade has cut through the material and just before the head comes to
14Bow Weight Adjustment Bow weight is one of the most important adjustments of the saw. If the bow weight is not set properly, one can expect poor pe
15Maintenance Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main s
16Base and Bed Assembly
17Saw Arm Assembly – HBS‐916W
18Saw Arm Assembly – HBS‐1018W
19Parts List for HBS-916W, HBS-1018W Index No. Part No. Description Size Qty 1 ... HBS916W-01 ...Base (S/N 8081108 and lower)
2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au
20Index No. Part No. Description Size Qty 39 ... TS-1490041 ...Hex Cap Bolt ...
21Index No. Part No. Description Size Qty ... HBS916W-70A ...Electrical Panel Cover (S/N 8081109 and higher HBS-916W) ...
22Index No. Part No. Description Size Qty 100-2 ... TS-1551061 ...Lock Washer ...M
23Index No. Part No. Description Size Qty 127-1 ... HBS916W-127-1...Eccentric Sleeve (inside)(HBS-916W) ...
24Index No. Part No. Description Size Qty 157 ... HBS916W-157...Blade Guard ...
25Index No. Part No. Description Size Qty 188 ... TS-1524021 ...Set Screw ...
26Gear Speed Reducing Box Assembly
27Parts List for Gear Speed Reducing Box Assembly Index No. Part No. Description Size Qty 1 ... HBS916W-94-01...Oil Seal ...
28Electrical Connections – HBS-916W
29Electrical Connections – HBS-1018W
3 Table of Contents Warranty and Service ...
30NOTES
31
32 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.walterme
4 Warning 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on
5 21. Provide for adequate space surrounding work area and non-glare, overhead lighting. 22. Keep the floor around the machine clean and free of scr
6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model H
7 Uncrating and Cleanup Note: Read and understand the entire manual before attempting setup or operation. 1. Finish uncrating the saw and inspect fo
8 4. Carefully lift motor and line up holes in the motor mounting plate and the motor bracket. 5. Slide motor support shaft into motor mount bracket
9 To convert the HBS-916W from 115V to 230V, the following items will have to be changed: Main Motor – follow diagram inside junction box cover. Cool
Comments to this Manuals